Intellinet 525497 Manuel d'utilisateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 82
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
13
Step 3: Install the upper housing and make sure the housing is well installed.
Step 4: Complete the hardware installation as shown below.
Install PoE Injector
DC: Insert adapter
PoE: This jack is linked to the secondary port of the AP with RJ45.
LAN: This jack is linked to the LAN side of a PC/hub or router/ADSL modem device with RJ45.
There is no software driver or utility installation needed only the configuration settings. Refer to
Chapter 4 for software configuration.
Notice: It will take about 50 seconds to complete the boot-up sequence after powering on. The Power
LED will light, then the WLAN Activity LED will flash to indicate the WLAN interface is enabled and
operational.
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 81 82

Commentaires sur ces manuels

Pas de commentaire